Configuring A Connection For Fiery Link - Canon ColorPASS-Z5000 Getting Started

75 Installing ColorPASS software and fonts
8. With the ColorPASS selected in the list of available servers, click OK to begin using
Fiery Spooler.
Modifying the configuration
You should edit the configuration whenever there is any change to your ColorPASS or
network, such as an IP address or device change. First change the specific ColorPASS
Setup information before configuring the connection.
T
O MODIFY THE CONFIGURATION
1. In the Chooser dialog box, click Option.
2. To edit information for a ColorPASS, select the ColorPASS by its IP address or DNS
name and click Modify. Edit information in the Settings dialog box as necessary, and
click OK when finished.
3. To add a new ColorPASS, click Add. Configure the Settings dialog box as outlined in
step 4 through step 6 in the previous procedure.
4. To remove a ColorPASS, select the ColorPASS by its IP address or DNS name and click
Remove.
The list of available servers reflects the modifications you have made.
Configuring a connection for Fiery Link
You can use Fiery Link to monitor the status of ColorPASS servers and view
information about the print jobs sent to them.
When you click the Edit Fiery List button, all ColorPASS servers on the local subnet
appear in the Available Fierys list of the My Fiery List dialog box. You can specify
which ColorPASS servers to connect to and monitor from this dialog box. If the
ColorPASS is not in your local subnet, you can use Fiery Link options to manually
configure a connection, or you can perform an advanced search to locate and connect
to ColorPASS servers anywhere on the network. The procedures below describe
locating and connecting to a ColorPASS server using manual and advanced search
methods. For information on using Fiery Link, see the Printing Guide.
Fiery Link is supported over TCP/IP only.
N :
OTE
: