Table of Contents
Advertisement
9.2 COLLAPSE THE ARRA Y AND MOVE THE PINS TO THE STORAGE POSITION
STEPS:
•
Lower the array until the front wheels touch the ground. The array should start to roll backwards and, as the array is lowered,
1
the cabinet-to-cabinet angles of the bottom five cabinets will close to the 12˚ position.
•
Once the lowest four boxes are entirely collapsed, and the gap between the fourth and fifth cabinets (from the bottom) is
2
closed, work from the bottom cabinet up and set the link bars of the lowest four cabinets to the 12˚ STORAGE position.
•
Remove the rear link pin from the fifth cabinet. This pin should move easily, as the weight of the array is being held by the front
3
wheels of the VT or Case resting on the ground.
•
Raise the array and allow the four cabinets to roll forward until the cart is resting safely on all four wheels.
4
•
Remove the front pins and separate the suspended array from the stack on the VT cart.
5
1
3
2
36
Rigging Manual
4
5
Advertisement
Table of Contents
