Table of Contents
Advertisement
STEPS (Continued):
•
Remove the link pin and install the stop pin into the angle selection plate of the first SRX9xxLA cabinet.
4
•
Place the first SRX9xxLA cabinet onto the base plate and pin the front two corners using the attached pins.
5
•
Lift the back of the SRX9xxLA and set the base plate's angle selection plate to the desired angle. Pin the SRX9xxLA cabinet
6
and the base plate's angle selection plate using the LINK PIN hole and pin.
CAUTION: Safe limits for ground-stacked arrays always assume that the stacking surface (floor and stage) is flat .
Do not deploy ground-stacked arrays on non-flat surfaces to avoid tipping hazards .
4
44
5
6
Rigging Manual
Advertisement
Table of Contents
