Table of Contents
Advertisement
STEPS (Continued):
•
Use the electric hoist to raise the array. Be aware that the lower cluster may swing forward as it lifts off the ground.
5
•
Insert the stop pins of the top three cabinets of the lower stack.
6
•
Grab the lower cluster by the rear handlebar and gently pull back towards the rear of the array. While doing this, lower the array
7
until the front wheels touch the ground.
•
Continue lowering the array until the rear attachment points draw close together and the link pin can be inserted.
8
•
Lift the array off the ground, insert the stop pin between the fourth and fifth cabinets up from the ground, and remove the VT
9
or Case.
5
6
9
33
Rigging Manual
7
8
Advertisement
Table of Contents
