Table of Contents
Advertisement
8.2 A TT ACHING THE ARRA Y FRAME
After setting the angles of the first stack of cabinets in an array, follow the steps below for attaching the array frame. For easiest attach-
ment, separate the spreader bar from the extension bar.
STEPS:
•
Verify that the top cabinet is set to 0.5 degrees. Place the spreader bar on the top cabinet between the front two attachment
1
points and insert the pins. Consult LAC-3 software to determine whether the A, B, or C position is used. Ensure that both sides
are pinned in the same position.
•
Pin the extension bar to the spreader bar using the two pins provided. Consult LAC-3 for proper orientation. Ensure that both
2
pins are used to secure the two pieces together.
•
Pin the link bar of the top cabinet to the extension bar. Make sure to use the same A, B, or C position used in Step 2.
3
•
Attach the 1/2-inch shackle to the correct hole on the extension bar and connect the hoist.
4
1
5
4
3
4
29
Rigging Manual
2
Advertisement
Table of Contents
