Table of Contents
Advertisement
6.5 INST ALLING THE ACK1
STEPS:
•
Remove the four bolts that were pre-installed into the threaded M10 nuts.
1
•
Using the included hardware, place one split lock washer and then one washer onto each of the four bolts.
2
•
Line up the caster and re-install the four bolts and washers through the caster holes.
3
•
Repeat for the remaining three corners.
4
1
TOOLS REQUIRED: An 8 mm Allen Key is required to install the ACK1 caster kit. Apply a torque value of 3.9 Nm (35 in-
lbs) and non-permanent thread lock.
3
22
Rigging Manual
2
Advertisement
Table of Contents
