Related Manuals for Texas Instruments ADC16DX370EVM
Summary of Contents for Texas Instruments ADC16DX370EVM
- Page 1 ADC16DX370EVM User's Guide Literature Number: SLAU529A February 2014 – Revised December 2014...
-
Page 2: Table Of Contents
Configuring the ADC Device to Use a Device Clock and SYSREF from the LMK04828 ..........A.4.3 Providing an Alternate LMK04828 Reference Clock .......................... Revision History Table of Contents SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... - Page 3 ......................Low-Level Controls ......................Troubleshooting ................Meaning of LEDs on the TSW14J56EVM ..............Required State of Switches on the TSW14J56EVM SLAU529A – February 2014 – Revised December 2014 List of Figures Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated...
-
Page 4: Introduction
• Device register programming via USB connector and FTDI USB-to-SPI bus translator The digital data from the ADC16DX370EVM board can be quickly and easily captured with the TSW14J56EVM data capture board. The TSW14J56EVM captures the high-speed serial data, decodes the data, stores the data in memory, then uploads it to a connected PC through a USB interface for analysis. - Page 5 With proper hardware selection in the HSDC Pro software, the TSW14J56 device is automatically configured to support a wide range of operating speeds of the ADC16DX370EVM, but it may not cover the full operating range of the ADC device. Serial data rates (and corresponding sampling rates) of 7.4 Gb/s (370 MSPS) down to 1.6 Gb/s (80 MSPS) are supported.
-
Page 6: Equipment
Signal-path and clock-path cables, SMA or BNC (or both SMA and BNC) • +4 V, 2-A power supply and cable ADC16DX370EVM User's Guide SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 7: Setup Procedure
With the power off, connect the EVM to the TSW14J56EVM via the FMC connector as shown in Figure Check that the standoffs provide the proper height for robust connector connections. SLAU529A – February 2014 – Revised December 2014 ADC16DX370EVM User's Guide Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 8: Connect The Power Supplies To The Boards (Power Off)
3. Select the ‘ADC16DX370_LMF_222’ device from the ADC select drop-down in the top left corner and press 'Yes' to update the firmware. ADC16DX370EVM User's Guide SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 9: 3.10 Program The Lmk04828 Using The Configuration Tab On The Hsdc Pro Software
LEDs. Table 1. Default State of LEDs on the TSW14J56EVM During Typical Operation Status Blinking Blinking FPGA_DONE SLAU529A – February 2014 – Revised December 2014 ADC16DX370EVM User's Guide Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 10: 3.13 Capture Data Using The Hsdp Software
ADC16DX370EVM User's Guide SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 11: 3.14 Re-Verify Tsw14J56Evm Status Leds
NOTE: Note that D4 has changed to indicate that the JESD204B link is established. Table 2. Default State of LEDs on the TSW14J56EVM during Typical Operation Status Blinking Blinking FPGA_DONE SLAU529A – February 2014 – Revised December 2014 ADC16DX370EVM User's Guide Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 12: Device Configuration
The EVM has two configurable devices, namely the ADC16DX370 and LMK04828. The register map for each device is provided in the data sheets SNVS990 and SNAS605, respectively. ADC16DX370EVM User's Guide SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 13: Configuration Gui Intro Tab
Device Configuration www.ti.com Figure 4. Configuration GUI Intro Tab Figure 5. Configuration GUI ADC Core Tab SLAU529A – February 2014 – Revised December 2014 ADC16DX370EVM User's Guide Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 14: Tab Organization
Perform a generic read or write command to the device shown in the ‘Block’ drop-down box using with Read or Write Register the address and write data information buttons ADC16DX370EVM User's Guide SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 15: Low-Level Register Control Tab
Device Configuration www.ti.com Figure 6. Low-Level Register Control Tab SLAU529A – February 2014 – Revised December 2014 ADC16DX370EVM User's Guide Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 16: Evaluation Troubleshooting
• Use the free FT_PROG software from FTDI chip and verify that the on-board FTDI chip is able to connect to the EVM programmed with the product description ‘ADC16DX370EVM’. • Verify that the TSW14J56EVM is properly connected to the PC with a mini-USB cable and that HSDP software is not the board serial number is properly identified by the HSDP software. -
Page 17: Tsw14J56Evm Led Bank And Switch Configuration
Short pins 1 to 2 (HI setting) J8 (USB PWR) Short pins 1 to 2 JP9 (U8 ENB) Short pins 2 to 3 SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 18: Hsdc Pro Settings For Optional Adc Device Configuration
CodeLoader 4 software and associated programming cable may be used to directly configure the LMK04828. Refer to the LMK04828 evaluation platform for proper configuration of the LMKSPI header. SLAU529A – February 2014 – Revised December 2014 Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... -
Page 19: Configuring The Adc Device To Use A Device Clock And Sysref From The Lmk04828
Changed 'ADC16DX370EVM_222' to 'ADC16DX370_LMF_222' in the Evaluation Troubleshooting section. NOTE: Page numbers for previous revisions may differ from page numbers in the current version. SLAU529A – February 2014 – Revised December 2014 Revision History Submit Documentation Feedback Copyright © 2014, Texas Instruments Incorporated... - Page 20 STANDARD TERMS AND CONDITIONS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, or documentation (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms and conditions set forth herein. Acceptance of the EVM is expressly subject to the following terms and conditions.
- Page 21 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 22 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 本開発キットは技術基準適合証明を受けておりません。 本製品のご使用に際しては、電波法遵守のため、以下のいずれかの措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・インスツルメンツ株式会社 東京都新宿区西新宿６丁目２４番１号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧くださ い。http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page SPACER EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS.
- Page 23 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2014, Texas Instruments Incorporated...
- Page 24 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.
- Page 25 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments ADC16DX370EVM...
Need help?
Do you have a question about the ADC16DX370EVM and is the answer not in the manual?
Questions and answers