Caps Lock Control; Read Code With Specific Initial Characters Only - Inateck BCST-54 Instruction Manual

Hide thumbs Also See for BCST-54:

Table of Contents

Enter Setup

Caps Lock Control

When using the BCST-54 on a Windows system, the content of a barcode may change with

the status of the caps lock key. To avoid errors caused by such change, you may enable the

"Rid Barcode of Caps Lock Control".

(*) Caps Lock Control Barcode

Rid Barcode of Caps Lock Control

Under this mode you may set 1-6 digits as initial characters, and the scanner will only

recognize the barcodes with these initial characters. Please refer to the Appendix I for the

supported characters.

Steps to enable reading barcodes with initial characters "A" and "6" are as below:

1. Read the "Enter Setup" barcode.

2. Read the "Set the Special Initial Character" barcode.

3. Read the "A" barcode in Appendix I;

4. Read the "6" barcode in Appendix I;

5. Read the "Exit and Save" barcode.

Note: After you set the initial characters by steps above, the BCST-54 will only recognize

the barcodes with specific initial characters. If you want to disable the function, please read

the "Enter Setup" - "Remove the Restriction on Initial Characters" - "Exit and Save".

Set Initial Characters

Only Read the Barcodes

with Specific Initial Characters

(*) Remove the Restriction on Initial Characters

Exit and Save

Table of Contents