Error Message Appears On A Pictbridge Compliant Device - Canon PIXMA MX7600 Series Quick Start Manual

Ink Info Number: 1699 Is Displayed
Cause
Machine detected ink (PGI-9PBK/Y/M/
C) out condition.
Error Message Appears on a PictBridge Compliant
Device
The following are the possible errors that may occur when printing directly from a PictBridge
compliant device, and the actions to resolve them.
Note
This section describes errors that are indicated on Canon-brand PictBridge compliant devices.
The error messages and operations may vary depending on the device you are using.
For errors on non-Canon PictBridge compliant devices, check the error message displayed on the LCD
and take the appropriate action to clear the error. For details, see "An Error Message Is Displayed on
the LCD" on page 133.
For the errors indicated on the PictBridge compliant device and their solution, also refer to the
instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message On
PictBridge Compliant
Device
"Printer in use"
"No paper"
"Paper jam"
"Printer cover open"
"No Print Head"
"Waste tank full" / "Ink absorber full"
"No ink" / "Ink cassette error"
See ""Printer detected ink out condition. Stop printing, then replace the ink tank."
(when printing is in progress) / "Printer detected ink out condition of the following
ink. Replace the ink tank." (when printing is not in progress) U182" on page 135.
If the machine is printing from the computer or warming up, wait until the job
ends. When it is ready, the machine starts printing automatically.
If the machine does not start printing, check whether an error message is
displayed on the LCD of the machine or not.
If the "The transport unit may not be clean. Perform sheet cleaning." Error
message is displayed, refer to "Cleaning the Inside of the Machine with a
Cleaning Sheet" on page 129 and perform sheet cleaning.
If the "Ink quality maintenance is complete. Continue printing?" error
message is displayed, press the OK button.
Load paper in the paper source and select Continue
PictBridge compliant device.
* To resume printing, you can also press the OK button on the machine instead
of selecting Continue.
Select Stop in the display on your PictBridge compliant device to stop printing.
Remove the jammed paper, load new paper, press the OK button on the
machine and try printing again.
Close the Scanning Unit (Printer Cover) on the machine.
The Print Head is not installed or is defective.
For details on how to resolve the error, see ""Print head is not installed. Install
the print head." U051" on page 133.
The ink absorber is nearly full.
For details on how to resolve the error, see ""The ink absorber is almost full.
Press OK to continue printing. Contact the service center."" on page 136.
The color, black, or clear ink tank is not installed properly or empty.
Check the error message displayed on the LCD and take the appropriate action
to resolve the error. See "An Error Message Is Displayed on the LCD" on
page 133.
Action
Action
*
in the display on your
Troubleshooting 161