Canon PIXMA MX7600 Series Quick Start Manual page 106

No. Cause
#022 Try again.
#037 Memory is full.
#085 TRY AGAIN IN BLACK & WHITE
STOP
RX Report
Your machine can print a RX (reception) report after receiving a fax, confirming whether the
reception was completed successfully. At purchase, RX reports are set not to print at all. You can
set the machine to print the report every time it receives a document, or only when an error
occurs.
Note
For details on the RX report setting, refer to "RX report" in "Device Settings" of the User's Guide
on-screen manual.
For the errors when you receive a fax, see "Errors when you receive a fax" on page 102.
Errors when you receive a fax
If an error occurs when you receive a fax, the error number is printed in the RX report.
The causes corresponding to the error numbers are as follows.
No. Cause
#003 It takes too long to receive a page.
#005 No answer.
#037 Memory is full.
STOP
MULTI TX Report
Your machine prints out a MULTI TX (transmission) report after sending a same document to
several destinations, confirming whether the transmission to them was completed successfully.
102 Faxing
The fax/telephone number registered to the one-touch speed dial or
coded speed dial is wrong.
Check the recipient's fax/telephone number, correct the fax/telephone
number registered to one-touch speed dial or coded speed dial, and
then send the document again.
The machine could not send a document because its memory is full.
Resend the document after deleting contents in memory.
See "Deleting a Document in Memory" on page 97.
The recipient's fax machine is not color-compatible.
Resend the document in black & white.
The Stop/Reset button was pressed to cancel sending the document.
Resend it if necessary.
Contact the sender and have him/her divide the fax or set the image
quality (fax resolution) to lower and resend it.
When receiving a fax manually, the machine could not detect the signals
from the sender's fax machine.
Contact the sender and have him/her resend it, or set the machine to
receive the fax automatically.
The machine could not receive a fax because its memory is full.
Delete contents in memory, then ask the sender to resend the fax.
See "Deleting a Document in Memory" on page 97.
The Stop/Reset button was pressed to cancel receiving the fax.
Contact the sender and have him/her resend it if necessary.
Action
Action