Battery Type - Epever Tracer-AN Series User Manual

3.4 Battery Type

 Operating Steps
Under Battery Voltage interface, long press ENTER button enter into the interface of Battery
type setting. After choosing the battery type by pressing SELECT button, waiting for 5 seconds
or pressing ENTER button again to modify successfully.
 Battery Type
①Sealed (Default)
④ User(Apply to "MT50" and "PC software "Solar Station Monitor"）
Battery Voltage Parameters (parameters is in 12V system at 25℃, please use double
value in 24V.)
Battery charging setting
Over Voltage Disconnect Voltage
Charging Limit Voltage
Over Voltage Reconnect Voltage
Equalize Charging Voltage
Boost Charging Voltage
Float Charging Voltage
Boost Reconnect Charging
Voltage
Low Voltage Reconnect Voltage
Under Voltage Warning
Reconnect Voltage
Under Volt. Warning Volt.
Low Volt. Disconnect Volt.
Discharging Limit Voltage
Equalize Duration (min.)
Boost Duration (min.)
NOTE:
1) When the battery type is sealed, gel, flooded, the adjusting range of equalize duration is 0
to180min and boost duration is 10 to180min.
2) The following rules must be observed when modifying the parameters value in user battery
type (factory default value is the same as sealed type):
a. Over Voltage Disconnect Voltage > Charging Limit Voltage ≥ Equalize Charging Voltage ≥
Boost Charging Voltage ≥ Float Charging Voltage > Boost Reconnect Charging Voltage.
b. Over Voltage Disconnect Voltage > Over Voltage Reconnect Voltage
c. Low Voltage Reconnect Voltage > Low Voltage Disconnect Voltage ≥ Discharging Limit
Voltage.
d. Under Voltage Warning Reconnect Voltage > Under Voltage Warning Voltage ≥
②Gel ③Flooded
Sealed
16.0V
15.0V
15.0V
14.6V
14.4V
13.8V
13.2V
12.6V
12.2V
12.0V
11.1V
10.6V
120
120
18
Gel Flooded
16.0V 16.0V
15.0V 15.0V
15.0V 15.0V
——
14.8V
14.2V 14.6V
13.8V 13.8V
13.2V 13.2V
12.6V 12.6V
12.2V 12.2V
12.0V 12.0V
11.1V 11.1V
10.6V 10.6V
——
120
120 120
User
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
9~17V
0~180
10~180