Evenflo NurtureMax Owner's Manual page 24

3
If level line is not level with the ground, uninstall
the base and place a tightly rolled towel or small
blanket beneath the front edge of the base in order
to provide enough recline for an infant's head to lie
back comfortably. Then buckle the vehicle belt and
continue with step 4.
IMPORTANT: Infants may have difficulty breathing when
in a sitting position. Make sure they recline enough for
their head to lie back comfortably and safely. Failure to
properly recline the child restraint could increase the
child's risk of serious injury or death.
4
LAP BELT
IMPORTANT: Some vehicle belts cannot be switched
into locking mode for child restraint installation. It may
be necessary to use a locking clip in these situations. To
install a locking clip, refer to page 46.
Refer to the vehicle owner's manual to determine which
type of belt retractor is in the vehicle.
24
Installing the Base with the
Vehicle Seat Belt
Lock the vehicle seatbelt.
Pull the shoulder belt tightly
to remove all slack from the
lap portion of the vehicle
seat belt and, at the same
time, push down on the
base using your full weight.
Check to be sure the base
is secured in the vehicle
seat.
LAP/SHOULDER
BELT