Cleaning/Maintenance; Base (6); Trimmer Housing (3) - Silvercrest SMT 3 A1 Operating Instructions And Safety Instructions

SilverCrest SMT 3 A1
Turn the multi-trimmer on.
•
Position the beard contour trimmer (9) perpendicular to
•
the skin and move it slowly and evenly, alternating in and
against the direction of hair growth. Repeat this process
until the desired trim is obtained.

9. Cleaning/maintenance

Always turn the multi-trimmer off before cleaning.
•
Do not use abrasive or corrosive cleaning agents. The
•
surfaces of the multi-trimmer can be damaged.
Never immerse the trimmer housing (3) in water for
•
cleaning. It could be irreparably damaged.
Use the cleaning brush (7) to remove hair from the blades
•
(12, 13, 15).
After cleaning, put a few drops of acid-free oil on the
•
blades (12, 13) of the eyebrow trimmer attachment (5)
and bear contour trimmer (9) every so often.

9.1 Base (6)

Clean the base (6) with a dry or slightly damp cloth.
•

9.2 Trimmer housing (3)

Remove all attachments (2, 5, 9) and clean the trimmer
•
housing (3) with a dry or slightly damp cloth.
50 - English