Cleaning And Maintenance Of The Device - Silvercrest SFR 36 A1 Operating Instructions Manual

__KRA100057_B5.book Seite 51 Montag, 26. Mai 2014 4:29 16
Wet shaving (only for battery
operation)
DANGER! Risk of electric
shock!
• The hand-held device and the plug-in
power unit|13 are not waterproof.
Wet shaving is only allowed when us-
ing battery power.
WARNING! Risk of material damage!
For wet shaving use shaving foam or lather
only; never use shaving gel or shaving
cream. This could adhere to the cutter
blocks|12.
• Before shaving, smooth a thin layer of
shaving foam on your face.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
• If shaving foam should clog the shav-
ing head|3, clean the shaving head
under running water (chapter "Clean-
ing and maintenance of the device" on
page 51).
Cutting long hair
Use the long hair trimmer|11on the back of
the shaver to shorten your beard and side-
burns.
1. Take off the protective lid|10.
2. Push the long hair trimmer|11 up.
3. Switch on the shaver with the on/off|6
switch.
4. After use, switch the device off, slide
the long hair trimmer|11 back to its
original position and clean the device
(chapter "Cleaning and maintenance
of the device" on page 51).
Designer stubble
NOTE: depending on beard growth and
shaving, the appearance of a designer
stubble can vary greatly.
To maintain a designer stubble look, shave
dry with an attached protective lid|10 reg-
ularly. In this case, the protective lid acts as
a designer stubble attachment.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
7. Cleaning and
maintenance of the
device
DANGER! Risk of electric
shock!
• The shaving head|3 can be cleaned
under running water. Disconnect the
device from the plug-in power unit ca-
ble|13 prior to doing so.
• The plug-in power unit and the corre-
sponding cable|13 must not be held
under running water and must not be
immersed in other liquids.
WARNING! Risk of material damage!
• Do not use any astringent or abrasive
cleaning agents.
• Do not place excessive pressure on the
shaving foils|1. They are thin and can
be damaged easily.
• Use the cleaning brush|14 for clean-
ing the cutter block|12 only. Under no
circumstances should the shaving
foils|1 be cleaned with it.
51
GB