General Safety Instruction - Viper ROS1300 Instructions For Use Manual

INSTRUCTION FOR USE

GENERAL SAFETY INSTRUCTION

Specific warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
• This machine must be operated by trained and authorized personnel according to guidance of the manual.
• Before performing any cleaning, maintenance, repair, or replacement procedure, read all the instructions carefully, ensure
the machine is OFF and disconnect the battery connector.
• Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids, or vapor. This machine is
not suitable for collecting dangerous powders.
• Do not wear jewelry when working near electrical components.
• Do not work under the lifted machine without supporting it with safety stands.
• When using lead (WET) batteries, they may emit inflammable gas under normal use, you must keep sparks, flames,
smoking materials and radiating, illuminating, and burning items away from the batteries.
• When charging lead (WET) batteries, they may emit hydrogen gas which may cause an explosion. You must ensure the
charging environment is well ventilated and away from flames.
WARNING!
• This machine is intended for COMMERCIAL USE, for example in hotels, schools, hospitals, factories, shops, and rental
businesses etc.
• Machines left unattended shall be secured against unintentional movement.
• To prevent unauthorized use of the machine, the power source shall be switched off or locked, for example by removing the
key to the main switch or the ignition key.
• Check the machine carefully before each use. Ensure that all the components have been well assembled. Loose components
may cause damage to people and properties.
• Never move the machine by pulling the battery charger cable. Do not pass the cable through a closed door or wind the cable
around sharp edges or corners. Do not run the machine over the battery charger cable. Keep the battery charger cable
away from heated surfaces.
• Do not charge the batteries if the battery charger cable or the plug are damaged.
• To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is charging. Before
performing any maintenance procedure, disconnect the battery charger cable from the electrical mains.
• The machine storage and working temperature must be between 0 °C and +40 °C, the humidity of air must be between 30%
- 95%.
• Do not use the machine on slopes with a gradient exceeding the specifications shown.
• Use brooms supplied with the machine or defined in the manual. Using other brooms could reduce safety.
• In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary, request assistance from
the authorized personnel or from an authorized Service Center.
• Take all necessary precautions to prevent hair, jewelry, and loose clothes from being caught by the machine moving parts.
• Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
• Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
• Do not lean liquid containers on the machine, use the relevant can holder.
• To avoid damaging the floor, do not allow the broom to operate while the machine is stationary.
• In case of fire, use a dry powder fire extinguisher. Do not use liquid fire extinguishers.
• Do not remove or modify the machine labels.
• Do not tamper with the machine safety guards and follow the scheduled maintenance instructions closely.
• Pay attention during machine transportation when temperature is below freezing point. The water in the solution tank and
in the hoses could freeze and cause serious damage to the machine.
4
ENGLISH