Hopper Dumping; Side Broom Installation - Viper ROS1300 Instructions For Use Manual

INSTRUCTION FOR USE

HOPPER DUMPING

1. Stop the machine (see the procedures in the previous paragraph).
2. Engage the parking brake.
3. Disengage the latch (A, Figure 13) by pulling its lower end.
4. Remove the hopper (D, Figure 13) by disengaging it from the inner
guides with the handle (B, Figure 13).
5. Discharge all the debris into special containers. To make
discharging procedure easier, there are three inner boxes (optional)
with handle (C, Figure 13) inside the hopper.
6. Install the inner boxes with handle (C, Figure 13), if equipped.
7. Install the hopper (D, Figure 13) and engage it to the inner guides,
then fasten it with the latch (A, Figure 13).

SIDE BROOM INSTALLATION

WARNING!
It is advisable to wear protective gloves when
replacing the side brooms because there can be
sharp debris between the bristles.
1. Drive the machine onto level ground and engage the parking brake.
2. Turn the ignition key to "O".
3. Release the spring (A, Figure 14), and remove the pin (B, Figure
14) from the side broom (C, Figure 14) shaft.
4. Install the side broom on the gearmotor shaft, insert the pin in the
holes (D, Figure 14) and engage the spring (A, Figure 14).
A
B
B
A
C
18
ENGLISH
C
Figure 13
D
Figure 14
D