Main Broom Replacement - Viper ROS1300 Instructions For Use Manual

INSTRUCTION FOR USE

MAIN BROOM REPLACEMENT

WARNING!
It is advisable to wear protective gloves when replacing the main broom because there can be sharp debris
between the bristles.
1. Drive the machine onto a level ground and engage the parking brake.
2. Turn the ignition key to "O".
3. Unscrew the knobs (A, Figure 22) and remove the left cover (B, Figure
22).
4. Unscrew the knob (A, Figure 23) and remove the drive hub bracket (D,
Figure 23).
5. Unscrew the knobs (B, Figure 23) and remove the broom compartment
cover (C, Figure 23).
6. Remove the main broom (E, Figure 24) along with the hub (J, Figure
26).
7. Check that the drive hub (F, Figure 24) is free from dirt or foreign
materials (strings, cords, etc.) accidentally rolled up.
8. The new main broom must be installed with the bristle pattern as shown
in the figure (G, Figure 24).
9. Install the new main broom and ensure that the hexagonal mesh (H,
Figure 24) correctly fits into the drive hub (F, Figure 24).
10. Install the hub (J, Figure 26) into the main broom.
11. Install the broom compartment cover (C, Figure 25) by tightening the
knobs (B, Figure 25).
12. Install the drive hub bracket (D, Figure 23) by tightening the knob (A,
Figure 23).
13. Install the left cover (B, Figure 22) by tightening the knobs (A, Figure
22).
14. Check and adjust the main broom height as shown in the previous
paragraph.
Figure 26
J
Figure 25
A
B
B
C
23
ENGLISH
A
Figure 22
B
D
C
Figure 23
F
G
H
Figure 24
B
B
E