Machine Storage During Long Inactivity; First Period Of Use; Maintenance; Scheduled Maintenance Table - Viper ROS1300 Instructions For Use Manual

INSTRUCTION FOR USE

MACHINE STORAGE DURING LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine chapter.
2. Disconnect the battery connector.

FIRST PERIOD OF USE

After the first 8 hours of use, check the machine fasteners and connecting parts for proper tightness and check the visible parts for
integrity and leakage.

MAINTENANCE

WARNING!
Maintenance procedures must be performed after the machine is turned off and the battery charger cable is
disconnected. In addition, carefully read the safety chapter in this instruction.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized Service Center.
This manual only describes the general and common maintenance procedures.
For other maintenance procedures that are not in below maintenance schedule table, please contact our Technical Support Department.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Battery (WET) electrolyte level check
Main broom cleaning
Side and main broom height check and adjustment
Dust filter cleaning and integrity check
Blade height and operation check
Filter shaker operation check
Main broom drive belt visual inspection
Flap pedal check and adjustment
Steering chain check and cleaning
Main broom drive belt replacement
Main broom motor and drive system motor carbon brushes
check or replacement
1. (*) For relevant procedures, refer to the Service Manual.
2. Daily or after using the machine.
3. Or before machine start-up.
4. Or more frequently in dusty areas.
Upon Every 10 Every 50
delivery hours hours
(1)
(2)
(3)
(*)
(*)
20
ENGLISH
Every 100 Every 200 Every 400
hours hours hours
(*) (4)
(*)
(*)
(*)