Dust Filter Cleaning And Integrity Check - Viper ROS1300 Instructions For Use Manual

Table of Contents

Advertisement

INSTRUCTION FOR USE

DUST FILTER CLEANING AND INTEGRITY CHECK

NOTE
Besides standard polyester filter, paper filters are also available. The following procedure is applicable to
both types.
1.
Drive the machine onto level ground and engage the parking brake.
2.
Turn the ignition key to "O".
3.
Remove the cover (A, Figure 30)
4.
Disengage the latch (F, Figure 30) by pulling its lower end.
5.
Remove the hopper (E, Figure 30) by disengaging it from the inner
guides with the handle (C, Figure 30).
6.
Unscrew the knobs (D, Figure 30) and remove the filter compartment
cover (B, Figure 30).
7.
Unscrew the knobs (A, Figure 31).
8.
Disconnect the filter shaker motor (C, Figure 31) connector (B, Figure
31).
9.
Remove the dust filter fixing frame (D, Figure 31).
10.
Remove the dust filter (E, Figure 31).
11.
In an outdoor area, clean the filter by shaking it on a level and clean
surface, tapping the side (A, Figure 32) opposite to the wire gauze (B,
Figure 32). Complete the cleaning procedure by using compressed air
(C, Figure 32) at a maximum of 6 bars (85 psi), blowing only from the
side of the wire gauze (B, Figure 32), at a minimum distance of 30 cm.
According to the filter type, observe the following cautions:
Paper filter (optional): Do not use water or detergents to clean it,
otherwise it can be damaged.
Polyester filter (standard): For better cleaning, the filter can be
washed with water and non-lathering detergents. This provides
better cleaning quality but reduces the life of the filter and causes
it to be replaced more frequently. Using improper detergents can
damage the filter.
12.
Check the filter body for integrity. If necessary, replace the filter.
13.
Clean the rubber gasket (A, Figure 33) of the cover and check it for
integrity and efficiency. If necessary, replace it.
14.
Assemble the components in the reverse order of disassembly, and
note the following:
Install the filter (E, Figure 31) with the wire gauze (B, Figure 32)
facing upwards.
Figure 33
A
B
C
D
E
F
25
ENGLISH
Figure 30
Figure 31
Figure 32

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

50000605

Table of Contents