Jetson JQUEST-BLK Manual

What's in the Box
1. Handlebar 8. Kickstand
2. Handbrake 9. Rear Fender
3. Release Lever 10. Rear Tire
4. Front Tire 11. Small Screw (x4)
5. Charing Port 12. Charger
6. Deck 13. Charging Cable
7. LED Lights
2 1
3
6
4 5 7 8
Please Note: Do not use the Rear Fender (9) as a Brake.
11
12 13
Specs & Features
Product Dimensions: 47.2" (L) × 21.6" (W) × 46.5" (H)
•
Product Folded Dimensions: 47.2" (L) × 21.6" (W) × 19.5" (H)
•
• Handlebar Height: 46.5"
Deck Size: 26" × 5.75"
•
• Weight Limit: 220 lb
Product Weight: 28.4 lb
•
Recommended Age: 12+
•
Tire Size: 8.5"
•
Max Speed: Up To 15 mph
•
Max Range: Up To 18 Miles
•
Battery: 36V, 7.5Ah Lithium-Ion
•
Motor: 250W Hub Motor
•
Charger: 100-240V
•
Charge Time: Up To 6 Hours
•
Climbing Angle: Up To 15°
•
Remember to be safe and
most importantly, have fun!
1. Get Started
Assembling the Handlebar
1.1
Tighten using the 4
small screws
Make sure the screws are tight and the Handlebar is secure.
Assembling the Handles
1.2
9
10
Connecting the Handles:
Take one handle and twist it towards the rider 3-4 times until it
•
catches. If it does not catch, try the other handle on the same side.
Tighten until the handle no longer turns. Repeat with the other handle.
Charging the Battery
1.3
Charging Port
Only use the included charger
•
Plug the charger into the wall before the Charging Port
•
Don't turn on the Quest while it's charging
•
• Charge the battery until it is fully charged - up to 6 hours
Replace the cover over the Charging Port when done
•
CHARGING INDICATOR ON THE CHARGER:
- Charging
- Charge Complete
Unfolding / Folding the Quest
1.4
Unclip the Handlebar from the
Rear Fender
Slide Handlebar into
Stem Tube
Release Lever
Close the Release Lever by lifting
it up until it clicks
• Reverse these steps to fold the Quest.
Operating the Quest
1.5
Battery Indicator
LCD Display
Powering On/Off - Hold the Power Button for 3 seconds to turn the
•
Quest on or off.
LCD Display - Shows current speed, speed mode, and battery life
•
remaining.
Light Function - Once the Quest is on, press the Power Button twice
•
to turn on the headlight and taillight. The light symbol will show on
the LCD Display.
Odometer - Press the Power Button 3 times to show the Odometer.
•
Press it another 3 times to return to the Speedometer.
BATTERY LEVELS:
Lights 1
Percentage 1-20%
SPEED SETTINGS:
Press the Power Button once to cycle through the speed settings.
1
Max speed up to
4 mph
*Adults must assist children in the initial adjustment procedures of the product.
2. Make Moves
Using the Thumb Throttle/
2.1
Handbrake
Handbrake
Lift Handlebars away
from Deck
Thumb Throttle:
Turn to lock
The Quest is motion activated. Push forward with one foot (about
5-8 kicks consecutively) before using the Thumb Throttle. Also,
please try to take it easy on the throttle until you get used to it.
Note: Cruise Control will activate when you hold the Thumb Throttle
for 8-10 seconds.
Handbrake:
Lock the Release Lever
Squeeze the Handbrake slowly to avoid stopping abruptly or losing
control.
Adjusting the Handbrake
2.2
Speed mode
Power Button
BRAKE ADJUSTMENT
Twist the barrel adjuster counterclockwise about a quarter to half
•
turn to tighten the brake.
• Twist the barrel adjuster clockwise about a quarter to half turn to
loosen the brake.
Please test the brake again before riding.
•
Quick Note: Leave space between the Folding Hook and the Bell,
otherwise the Bell will not work properly.
Riding the Quest
2.3
2 3 4 5
Place one foot in front.
21-40% 41-60% 61-80% 81-100% •
• Place the other foot in back, at a 70-90° angle.
Turn the handlebar to the left or right to make turns.
•
2 3
Max speed up to Max speed up to
8 mph 15 mph
Please Note: Images may not reflect exact appearance of actual product.
Thumb Throttle
Hold nut in
place
Twist Barrel
Adjuster