Step 10: Installing The Wi-Fi Router; Step 11: Project Commissioning Checklist - Trane Tracer Concierge BMTC015ABC012000 Installation Instructions Manual

Step 10: Installing the Wi-Fi Router

Note: The Concierge Controller in its pre-wired enclosure should be operating and
The optional Wi-Fi router is used when the Concierge Controller and the Concierge Display cannot
both be on the customer's Wi-Fi network.The router (Order Number: X13651632010) is set up to
allow the Concierge Controller and the Display to communicate on their own small (2 device) Wi-
Fi network.
1. Install the router near the pre-wired enclosure containing the Concierge Controller.
2. Plug router into the accessory outlet in the enclosure.
Avoid damage to the contents of the pre-wired enclosure when opening a knockout for the
Ethernet cable.
3. Connect the Ethernet cable included with the router to the router on one end and into Concierge
Figure 13. Concierge controller ethernet ports detail
4. Connect power to the Wi-Fi router. The pre-wired enclosure containing the Concierge

Step 11: Project Commissioning Checklist

Verify that hardware installation is complete:
Verify the Concierge Controller panel is attached to the wall and power is wired to it.
Verify Concierge Controller Air-Fi® Wireless is addressed properly per the submittal and/or the
Air-Fi® Wireless Network Best Practice guide BAS-SVX55C-EN.
Verify the Ethernet Cable for the customer's network is connected to Concierge Controller
Ethernet Port 1 (if applicable).
Verify that any rooftop units with Air-Fi® Wireless are connected and addressed properly per the
submittal and/or the Air-Fi® Wireless Network Best Practice guide BAS-SVX55C-EN.
BAS-SVN040B-EN
communicating to all the equipment before installing the Wi-Fi router.
Controller's Port 2 on the other. See the following figure.
Controller also contains a convenience outlet.
NOTICE
Installation
19