Step 6: Wire I/O; Step 7: Mount The Display - Trane Tracer Concierge BMTC015ABC012000 Installation Instructions Manual

Installation

Step 6: Wire I/O

The field I/O wiring is specific for each application.

Step 7: Mount the Display

Note: The display is designed for conditioned indoor environments only. Mount the display where
The display mounts to the wall using a VESA mount. The required VESA mounting bracket size is
75 mm x 75 mm. A VESA mount is included with the display, but any standard VESA mount should
be acceptable. Brand, tilt, swivel and any other features are acceptable.
1. Select the wall space to mount the display. Mounting constraints are as follows:
2. Disassemble the VESA mount.
3. Install the wall section onto the wall.
4. Install the display section of the VESA mount onto the display enclosure using the four (4)
5. Re-assemble the VESA mount so the display is now on the wall.
6. For ease of initial setup, connect an Ethernet cable between the display and Concierge
7. If mounted near the enclosure, plug the display into the accessory outlet in the enclosure.
16
Module Rotary Dial Terminals
XM30 01
XM30 01
XM30 01
XM30 01
XM32 02
XM32 02
XM32 02
XM32 02
occupants can access it for comfort/setpoint control and minor schedule modifications.
• The display must be powered continuously, so mount it near an electrical outlet or near the
enclosure with the accessory outlet.
• The display communicates to the Concierge Controller using either Wi-Fi or Ethernet cable
connection. Use standard Wi-Fi guidelines to select the display location.
• The display should be accessible for any users that are allowed to make adjustments using
the display.
screws included with the VESA mount.
Controller's Ethernet Port 2. Later, set up a Wi-Fi router or put both the display and Concierge
Controller on the customer's network.
Name
Outside Air
UI/AO 1
Temperature
UI/AO 2 N/A
UI/AO 3 N/A
UI/AO 4 N/A
BO1 XM32 Binary Output 1
BO2 XM32 Binary Output 2
BO3 XM32 Binary Output 3
BO4 XM32 Binary Output 4
Notes
Thermistor
Not used
Not used
Not used
Must be wired as dry contact; used for lighting
output or other (for example, exhaust fan)
Must be wired as dry contact; used for lighting
output or other (for example, exhaust fan)
Must be wired as dry contact; used for lighting
output or other (for example, exhaust fan)
Must be wired as dry contact; used for lighting
output or other (for example, exhaust fan)
BAS-SVN040B-EN