Replacing A Frypot - Frymaster OCF30E Service & Parts Manual

Remove two screws to access contactor box components above the filter
.
pan
4. The contactors and relays are held on by threaded pin studs so that only removal of the nut is
required to replace the component.
5. After performing necessary service, reverse steps 1-4 to return the fryer to operation.

1.8 Replacing a Frypot

1. Drain the frypot into the filter pan or, if replacing a frypot over the filter system, into a Shortening
Disposal Unit (SDU) or other appropriate METAL container. If replacing a frypot over the filter
system, remove the filter pan and lid from the unit.
DO NOT drain more than one full frypot into the SDU at one time.
2. Disconnect the fryer from the electrical power supply and reposition it to gain access to both the
front and rear.
3. Open the control panel by removing the two screws on the bottom of the bezel. Carefully lower the
bezel.
4. Remove the two screws from the upper corners of the control panels and allow them to swing
down (see photo on page 1-1).
Left and right views of mechanical contactor box components.
DANGER
1-7