Sharp AR-FX7 Service Manual page 27

66-33
Purpose Operation test/check
Function (Purpose) Signal detection check
Section FAX
Item Operation
Operation/Procedure
Signal detection is checked and the result is displayed.
Note: Executable only when the FAX is installed.
66-34
Purpose Operation test/check
Function (Purpose) Communication time measurement display
Section FAX
Item Operation
Operation/procedure
The send/receive test is performed, and the time required for send/
receive of the image data in the test is measured and displayed.
Setup on the user Communication
side when executing means
communication Picture quality
Density
ECM
Sender information
Measuring Send From flag reception before sending of
range image data until sending of RCP frame
Receive From flag reception before reception of
image data until reception of RCP frame
Mode when measuring Used to make communication not in a
simulation process but in the normal screen
and measure the time.
How to check the time Enter the simulation for communication time
check and check the time.
Measuring unit msec
When there are two or more send/receive operations of image data in
one communication, only the time of the last send/receive data near
the end is measured.
Note: Executable only when the FAX is installed.
66-37
Purpose Adjustment/Setting/Check
Function (Purpose) Speaker sound volume adjustment
Section FAX
Operation/procedure
The following test sound is delivered to the line and the speaker to
adjust the sound kind and volume.
The send level to the line is the set value of soft SW.
The set values of the selected sound kind and volume are written to
each soft SW.
1. Sound kinds pattern
RINGER
LINE MONITO Line monitor sound (Test
ON HOOK
SCAN FINISH
TX/RX FINISH Communication finish
DTMF
LAR: (MED. Value + 1)
MED: (SMA value +1) - (LAR value - 1)
SMA: 1 - (MED. Value + 1)
2. Sound volume pattern
Note: Executable only when the FAX is installed.
66-41
: Memory send
: Normal Character
: Lighter
: ON
Operation/procedure
: OFF
When the [START] key is pressed, the call signal from CI pin is
detected to deliver the call sound to the line and the speaker. The vol-
ume of call sound follows the soft SW.
Signal detection and delivery of pseudo-call sound at detection are
executed until the interruption command is provided by pressing the
[CUSTOM SETTINGS] key.
Note: Executable only when the FAX is installed.
66-52
Operation/procedure
When the [START] key is pressed, the machine ringer and the pseudo-
ringer would ring.
By pressing [CUSTOM SETTINGS] key, the operation can be can-
celed.
AR-FX7 SIMULATION 6 - 12
Sound kinds (Test sound)
Call sound
sound: communication
signal sound)
On-hook (Test sound,
communication signal
sound)
Scan finish sound
sound
DTMF send sound
Purpose Adjustment/Setting/Check
Function CI signal check
(Purpose)
Purpose Operation test/check
Function Ringer check
(Purpose)
Sound volume set value
DEF. LAR. MED. SMA.
DEF. LAR. MED. SMA.
DEF. LAR. MED. SMA.
DEF. LAR. MED. SMA.
DEF. LAR. MED. SMA.
DEF. LAR. MED. SMA.
1