Installation Considerations - HYDRALOOP H150 Installation Manual

Basic installation steps:
1. Check if system and installation will comply with applicable country, state or local regulations and
that the preparation of the plumbing is preventing and protected against back flow and cross
connection assuring protection of the public water supply. (Ch 6.1, 6.2 and 8)
2. Check that the greywater pipes and the distribution pipes of the recycled water have been properly
installed in accordance with the recommendations in this manual. (Ch 6.1, 6.2)
3. Place the Hydraloop unit on its planned position (Ch 6.4)
4. Connect incoming greywater to the inlet on the top, in combination with lift pump if necessary. (Ch
6.5, 6.6)
5. Connect backup water inlet connection. (Ch 6.7)
6. Connect Hydraloop recycled water outlet connections (Ch 6.7)
7. Connect Hydraloop wastewater outlet to sewer (Ch 6.7 and 6.8)
8. Plug 100-240V power cord into wall socket
9. Run the commissioning test using the Hydraloop App (Ch 7)

6.1 Installation considerations

Note; The plumbing connections for greywater and backup water inlets and recycled water outlets and
Hydraloop wastewater outlet can be installed concealed in the floor, under the floor or mounted on the floor
& wall behind the Hydraloop unit. An example of concealed connections can be seen in the left images
below. On-floor & wall connections can be seen in the right images.
HL-20210202 Hydraloop Installation Manual
9