Advertisement
Quick Links
Installation Manual – Hydraloop H300 1.5
SAFETY
GENERAL SAFETY INSTRUCTIONS
WARNING
Read this manual before installing and/or operating your Hydraloop device.
•
The Hydraloop device produces NON-POTABLE water. DO NOT use the Hydraloop
•
device output water for potable use. Please note that the backup water outlet and
non-potable outlet are close in proximity.
The device should only be opened or serviced by Hydraloop staff or certified
•
Hydraloop partner and/or installers. Risk of electric shock may occur.
The Hydraloop device should be installed according to installation manual for safe
•
operation.
WARNING
A damaged power cable should always be replaced by Hydraloop staff or certified
•
Hydraloop partner and/or installers.
Always disconnect the Hydraloop device from backup water supply before servicing
•
or performing maintenance.
ATTENTION
Following commissioning and/or work on the Hydraloop device, lines should always
•
be checked for leaks and potential cross connection.
RECOMMENDATIONS
ATTENTION
The Hydraloop device should only be installed indoors with an ambient temperature
•
between 14-35°C | 57-95°F.
The Hydraloop device should never be exposed to sunlight.
•
Reusable water should never be connected to a bidet and/or a toilet hand-shower.
•
The Hydraloop device should always be accessible for service and maintenance.
•
ATTENTION
The Hydraloop device should only be moved or transported in an upright, vertical
•
position.
Care should be taken not to damage the exposed underside of the device.
•
ATTENTION
Never direct greywater from kitchen sinks, floor drains or dishwasher to the
•
Hydraloop device.
Only use greywater from shower/bath, and optionally from washing machines.
•
In cases of excessive soap use, foam may form within the Hydraloop device.
•
Hydraloop Installation Manual H300 1.5 – EN - 20240805
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for HYDRALOOP H300 1.5
Summary of Contents for HYDRALOOP H300 1.5
- Page 1 Please note that the backup water outlet and non-potable outlet are close in proximity. The device should only be opened or serviced by Hydraloop staff or certified • Hydraloop partner and/or installers. Risk of electric shock may occur.
- Page 2 RESPONSIBILITY AND LIABILITY MANUFACTURER Hydraloop guarantees the proper working of the device according to its general sales conditions. As a manufacturer, Hydraloop is not liable in the following cases: Failure to follow instructions for Recycle Ready preparation, installation, • maintenance, and/or operation of the device Inadequate or insufficient maintenance of the device •...
- Page 3 (Inlet Standard) H300 31.49 13.19 82.48 (Inlet Diverter) H300 PACKAGED 32.08 31.50 86.54 199.55 – H300 DISPLAY 31.88 13.19 80.51 88.20 – MODEL H300 DISPLAY 32.08 13.58 86.54 110.25 – MODEL PACKAGED Hydraloop Installation Manual H300 1.5 – EN - 20240805...
- Page 4 The Hydraloop device will be transported to your location mounted and strapped onto a HL-Transport plate, wrapped in protective packaging, and mounted onto a wooden pallet. When moving the Hydraloop device, it is important to always keep it in an upright, •...
-
Page 5: Installation Considerations
Hook the mounting hole of the H300 1.5 top plate onto the square shoulder hook, which is drilled and fasten into the wall, so the Hydraloop device is fixed to the wall and protected against falling over. - Page 6 4. *Place the front plate in a way that the front plate cannot fall and be damaged. H300 1.5 greywater inlet installation Blue sealing ring Greywater inlet Incoming water sensor Incoming water sensor Ventilation valve Hydraloop Installation Manual H300 1.5 – EN - 20240805...
- Page 7 REUSABLE WATER OUTLETS The Hydraloop device comes equipped with two standard outlet valves, (1) dedicated for feeding multiple toilets (no high flush toilets) and (1) dedicated for feeding one washing machine. There is also an optional auxiliary outlet valve that can be added to feed the garden/pool.
- Page 8 40/50 H300 1.5 WASTEWATER OUTLET INSTALLATION The 40 mm |1 1/2" OD wastewater line at the bottom of the H300 1.5 needs to be connected to the sewer with the PVC eccentric adapter ring or *rubber reducing sleeve (40 mm ID or 40/50) through the floor (first image) or backwards into the wall (second image).
- Page 9 H300 1.5 drain line connected to sewer system through the back wall. INTRODUCING AN EXTERNAL LIFT PUMP If the Hydraloop device is on the same or higher floor as the shower/bath or washing machine an external lift pump needs to be incorporated to have the source greywater enter the device.
-
Page 10: Installation
3. Select priority options connected to toilets, washing machine, auxiliary outlet, and lift pumps 4. Activation of the H300 1.5 when all device systems have passed the validation steps. This will occur automatically once all HDM steps have been completed. - Page 11 STARTUP TIME The Hydraloop device requires a minimum of 21 days (3 weeks) and 20 showers to develop the biological treatment process in the T2 tanks and become fully operational. The greywater treatment will start from the initial start-up; however, this reusable water will be purged into the sewer and the backup water will be supplied instead.
-
Page 12: Warranty
In the event these substances enter the H300 1.5, it can be damaged, and the water treatment can be affected. There is a function in the APP where the greywater from the T1 tank can be wasted to the sewer if you suspect foreign matter has entered the Hydraloop device (i.e.,... - Page 13 Noise level = + 44 dB DATA PLATE / SERVICE LABEL The Hydraloop device has a permanent data plate attached to the top of the device that should look like the example below. Hydraloop Installation Manual H300 1.5 – EN - 20240805...
- Page 14 This document and its contents are the sole property of Hydraloop Systems B.V. and must not be copied to a third party, either in part or whole, without the prior written consent of Hydraloop Systems B.V. Hydraloop reserves the right to change the specifications stated in this document.
Need help?
Do you have a question about the H300 1.5 and is the answer not in the manual?
Questions and answers