Stacked Blade Assembly - Ninja CB352SM Owner's Manual

USING THE POWER BLENDER &
PROCESSOR PITCHER & STACKED BLADE ASSEMBLY
IMPORTANT: Review all warnings on
pages 4–6 before proceeding.
IMPORTANT: As a safety feature, when
the unit is powered on, if the pitcher and
lid are not properly installed, the timer
will display "- -" and the motor will be
disabled. If this happens, repeat steps 2
and 5 on this page. When the pitcher and
lid are properly installed, and the unit is
powered on, the program button LEDs
will illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The pitcher lid handle will not fold
down unless it is attached to the pitcher.
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Lower the pitcher onto the motor base.
The handle should be aligned slightly
to the right and the pitcher should be
oriented so the LOCK symbols are visible
on the motor base. Rotate the pitcher
clockwise until it clicks into place.
3 Exercising care, grasp the Stacked Blade
Assembly by the top of the shaft and
place it onto the drive gear inside the
pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the MAX LIQUID
line on the pitcher.
5 Place the lid on the pitcher. Press down on
the handle until it clicks into place. Once
the lid is locked in place, press the Power
button to turn unit on. The available
program buttons will illuminate and the
unit will be ready for use.
SG ninjakitchen.sg | MY ninjakitchen.my
11