Table of Contents
Advertisement
INTRODUCTION
Thank you for your purchasing Kansai Special's DLR series.
Read and study this instruction manual carefully before beginning any of the
procedures and save it for later use.
1.
This instruction manual describes adjustments and maintenance procedures on this
machine.
2.
Before starting the machine, check to make sure the pulley cover, safety cover, etc.
are secured.
3.
Before adjusting, cleaning, threading the machine or replacing the needle, be sure to
turn off the power.
4.
Never start the machine with no oil in the reservoir.
5.
Refer to the parts list as well as this instruction manual before performing preventive
maintenance.
6.
The contents described in this instruction manual are subject to change without notice.
I n d i c a t i o n o f s e r i a l n u m b e r
Zip code
Model
2 2 0 0 0 0 1
Serial number
The date of manufacture
Year 2022
DLR
series
CONTENTS
1-1 Stitch type ················································ 1
1-2 Model ······················································ 1
2-1 Needles ···················································· 1
2-2 Replacing the needle ·································· 1
2-3 To thread the machine ······························· 2
pulley runs ·············································· 4
3-2 Motor & belt ············································· 4
4. LUBRICATION
4-1 Oil ·························································· 5
4-2 To fill the machine with oil ························· 5
4-3 Replacing the oil and the filter element ········ 5
5-1 Cutting the machine table ·························· 6
5-2 To install the machine ································ 7
6-1 To install the looper ··································· 7
6-2 Looper left-to-right movement ····················· 8
6-3 Looper setting distance ······························ 8
6-4 Needle height ··········································· 9
6-6 Length of the looper connecting bar ············ 10
7-1 Position of the needle guard (rear) ············· 10
7-2 Position of the needle guard (front) ············ 10
8-1 Feed dog height & tilt ······························ 11
8-2 Stitch length ··········································· 11
8-3 Feed dog height &tilt
（SPF） ········· 11
8-4 Left and right feed dog height (SPF） ········ 11
9-1 Presser foot pressure ······························· 12
10-1 Manual lever ········································· 12
10-2 To adjust the puller pressure ··················· 12
puller ··················································· 13
10-4 Upper puller angle adjustment (SPF) ········· 13
10-5 Lower puller angle adjustment (SPF) ········· 13
(SPF) ·········· 13
10-7 The minor adjustment of rear
pullerfeeding amount
(SPF)··········· 14
11-1 Thread tension adjustment ······················ 14
11-2 Position of the needle thread eyelet ··········· 14
11-3 Adjusting the needle thread guard ············ 15
11-4 Adjusting the looper thread eyelets ··········· 15
11-5 Position of the looper thread take-up ········· 15
of the front puller ·································· 16
··················· 16
DLR
series
Hide quick links:
Advertisement
Table of Contents
