Transmitting; Making Group Calls (Nxdn/ Dmr) - Kenwood NX-1300DE3 User Manual

TRANSMITTING

1
Select the desired zone and channel.
2 Press the button programmed as [Monitor] or [Squelch Off] to check whether
or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak to the microphone. Release the PTT switch to
receive.
• The LED indicator lights red while transmitting and green while receiving a
signal. This indicator can also be disabled by your dealer.
• For best sound quality, hold the transceiver approximately 3 ~ 4 cm (1.5
inches) from your mouth.
• In Site Roaming zones, the transceiver will search for the strongest signal
repeater and transmit using that repeater's frequency.

Making Group Calls (NXDN/ DMR)

You can select a group ID from the list to make a call to those parties on a channel.
1 Press the button programmed as [Group], [Group + Short Message] or
[Group + Status] to enter Group Call Mode.
Alternatively, press the button programmed as [Menu] to enter Group Call
•
Mode using the Menu Mode.
• The group ID list appears on the display.
2 Press the [ <B ] and [ C> ] buttons to select a Group ID/ name from the list
that has been programmed into your transceiver.
3 Press and hold the PTT switch to make the call.
• The " " indicator blinks. The Group name of the target transceiver are
displayed.
• Speak to the microphone as you would during a normal call.
13