Identifying External Components; Front Panel - LevelOne GSW-2475T User Manual

24-port 10/100/1000mbps gigabit ethernet web smart switch

Table of Contents

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators

of the Switch.

The figure below shows the front panels of GSW-2475T.

Figure 4. Front panel of 24-port Gigabit Ethernet Switch

LED Indicator:

Comprehensive LED indicators display the status of GSW-2475T and

the network (see the LED Indicators chapter below).

Gigabit Ethernet Ports (Port 1~24):

The Switch sixteen Gigabit twisted pair ports, supported auto negotiable

10/100/1000Mbps and auto MDI/MDIX crossover detection function, this

function gives true "plug and play" capability, just need to plug-in the

network cable to the hub directly and don't care if the end node is NIC

(Network Interface Card) or switch and hub.

These ports can operate in

half-duplex

mode

for

10/100Mbps

and

full-

duplex

mode

for

10/100/1000Mbps.

mini-GBIC Ports

GSW-2475T is equipped with two mini-GBIC ports, supported

optional 1000BASE-SX/LX mini-GBIC module.

Port 23 and 24 are the same ports with the mini-GBIC no.23 and 24

ports, when plug in the mini-GBIC module, the device will activate

mini-GBIC, and the RJ45 port will be disabled.

Note: When the port was set to "Forced Mode", the Auto

MDI/MDIX will be disabled.

Table of Contents