Table of Contents
Advertisement
4 Insert the new memory module in the slot:
a Align the notch on the gold edge of the module with the notch in the memory slot.
b Tilt the card and insert the module into the slot. Make sure the module is properly inserted.
c Push the memory module with moderate pressure into the memory slot until you hear a click.
You must utilize the same type of memory on all slots. The default memory is non-ECC SO-DIMM DDR4.
Important:
If you expand utilizing ECC SO-DIMM DDR4 memory, you must remove the original.
Note:
• Hold the memory module by its edges, and do not touch the gold connectors.
• When memory capacity is changed, the device will perform a memory check upon the next start up. This will
prolong the start up time by up to ten minutes. This behavior is normal and will only occur once.
Synology offers RAM modules
Note:
products/accessories/ram_railkit.
5 Replace the bottom lid. Replace and tighten the 2 screws you removed in step 3.
6 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on your
DiskStation.
To make sure DiskStation recognizes the new memory capacity:
1 Install DiskStation Manager (DSM). (See the next chapter for more information.)
2 Log in to DSM as admin or a user belonging to the administrators group.
3 Check
Total Physical Memory
If your DiskStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
1
Synology will not provide complete product warranty or technical support if non-Synology RAM modules are used for memory upgrade.
11 Chapter 2: Hardware Setup
1
for memory upgrade. For more information, please visit
in
Control Panel
>
Info
Center.
www.synology.com/
Advertisement
Table of Contents
