To remove the RAM Module:
1 Follow step 1 to 3 of the "To install the RAM module" section to shut down your DiskStation, disconnect the
cables, and then remove the bottom lid.
2 Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3 Hold the memory module by its notches and remove it from the slot.
4 Replace the bottom lid. Replace and tighten the screws removed in step 1.
5 Reconnect the cables removed in step 1. Now, you may turn on your DiskStation.
Attach M2D17 Adapter Card to DiskStation
Your DiskStation supports one M2D17 adapter card. To replace the long bracket with the M2D17 adapter card,
please follow the instructions below.
To install the M2D17 adapter card:
1 Press and hold the power button until you hear a beep sound to shut down your DiskStation. Disconnect all
cables from your DiskStation to prevent any possible damage.
2 Open the top cover of DiskStation by removing the 6 screws that secure the main unit.
12 Chapter 2: Hardware Setup