HP ProCurve 3400cl-48G Installation And Getting Started Manual page 42

Procurve series 3400cl switches
Hide thumbs Also See for ProCurve 3400cl-48G:
Table of Contents

Advertisement

Installing the Switch
Installation Procedures
LEDs
The RPS LEDs are located on the back of the RPS/EPS. These LEDs are
duplicated on the front of the device. The following graphic shows an example
of the back of the RPS/EPS. There are two green LEDs for each RPS port:
The following states provide status of an RPS/EPS port.
Fault
Off
On or Off
Off
Off
Blinking
Off
Blinking
2-22
Device Connected
Power Status
Device Connected LED
Device
Connected
Off
Off
On
On
Off
On
On
Power Status LED
!
Power
Message
Status
Off
Nothing Connected
On
Not a valid state - should never happen
Off
Switch is connected, RPS is available but
not required
On
RPS is powering the connected device
Blinking
RPS port is in fault mode
Blinking
Switch is requesting power, RPS can not
provide it
Off
Switch is unplugged, but RPS is powering
switch

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 3400cl-24g

Table of Contents