Table of Contents
Advertisement
Installing the external cooling fan
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Route the external cooling fan power cable into the system through the slot at the back of the chassis.
2. Align and insert the lower and upper hooks on the external cooling fan into the corresponding slots at the back of the
chassis.
3. Use the four screws to secure the external cooling fan to the chassis.
4. Connect the external cooling fan power cable to the FAN2 connector on the system board.
Figure 59. Installing the external cooling fan
Next steps
1.
Install the air
shroud.
2. Follow the safety guidelines listed in
Optional internal USB memory key
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
72
Installing and removing system components
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
Before working inside your
Jumpers and
connectors.
system.
system.
system.
Advertisement
Table of Contents
