Table of Contents
Advertisement
Next steps
Follow the procedure listed in
Installing the power interposer board
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Follow the safety guidelines listed in
Steps
1. Align the slots on the power interposer board (PIB) with the hooks on the power supply unit (PSU) cage and slide the PIB
until it snaps into place.
2. Secure the PIB to the chassis by using the screw.
3. Route the P3 power cable through the securing clip on the system board and connect power cable to the drive backplane.
Figure 86. Installing the power interposer board
Next steps
1. Install the cooling shroud.
2. Install the PSUs or PSU blank.
3. Follow the procedure listed in
96
Installing and removing system components
After working inside your
Safety
instructions.
After working inside your
system.
system.
Advertisement
Table of Contents
