Table of Contents
Advertisement
2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break
the thermal paste seal.
3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 73. Loosening the processor bracket
4. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor
tray.
5. Flex the outer edges of the bracket to release the bracket from the processor.
NOTE:
Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 74. Removing the processor bracket
Next steps
Install the processor into the processor and heat sink
86
Installing and removing system components
module.
Advertisement
Table of Contents
