Installing The Optical Or Tape Drive Blank - Dell Olympus O-T400 Installation And Service Manual

Figure 37. Removing the optical drive or tape drive blank
Next steps
1. Install the optical drive cage or tape
2. If applicable, install the

Installing the optical or tape drive blank

NOTE: Valid TBU configurations:
● HBA330 adapter can be connected to TBU and the PERC H740P, H730P, H330, HBA330 can be connected to the drive
backplane.
● HBA350i adapter can be connected to TBU and the PERC H750, H350, HBA350i can be connected to the drive
backplane.
For more information, see
Prerequisites
1. Follow the safety guidelines listed in
2. If applicable, remove the front
Steps
1. Align the guide on the drive blank with the slot on drive bay.
2. Slide the drive into the slot until the latch snaps into place.
drive.
bezel.
Backplane cable routing.
Safety instructions.
bezel.
Installing and removing system components 49