Table of Contents
Advertisement
Figure 27. Removing a drive blank
Next steps
1.
Install a drive or a drive blank.
Installing a drive blank
The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical.
Prerequisites
1. Follow the safety guidelines listed in
Safety
instructions.
2. If installed,
remove the front
bezel.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 28. Installing a drive blank
40
Installing and removing system components
Advertisement
Table of Contents
