Becker CentronicPLUS SWC541 PLUS Assembly And Operating Instructions Manual page 26

3s
5s
Identification of the hand-held transmitter
A colour can be assigned to the LED ring of the hand-held transmitter by
pressing the function button to make the device easier to identify. The stored
colour can be displayed by briefly pressing the function button. If the function
button is pressed for longer than 3 seconds, the LED ring flashes briefly. The
required colour can now be set by pressing the
available: press the function button again for longer than 3 seconds to store
the colour currently selected.
Battery status
Intermediate position I + II
The intermediate positions I + II are freely selectable positions for the shading
solution between the two limit positions. Each travel button can be assigned
one intermediate position. Both limit positions must be set before an interme-
diate position is set.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
26 - en
Press the STOP button for 3 seconds to display
the current status.
Automatic The LED ring lights up green.
mode:
Manual mode: The LED ring lights up red.
Different The LED ring lights up yellow.
modes:
You can toggle between manual and automatic
mode by pressing the STOP button for 5 seconds.
Battery status low
LED ring flashes yellow 4 times following normal
feedback.
Battery status empty
LED ring flashes red 4 times following normal
feedback.
or button. 9 colours are