Table of Contents
Advertisement
Installation
•
Do not install this appliance if it is
damaged in any way. Installing a
damaged appliance may invalidate the
warranty.
•
The water supply tap should be located
in an adjacent cupboard so that it can be
accessed after installation.
•
Ensure the appliance is level by adjusting
the feet as necessary.
•
Only use the water inlet supplied with the
appliance.
•
If the water pressure is above 10 bar, a
pressure relief valve should be used.
•
After connecting the water supply, check
to ensure there are no leaks.
•
The water outlet can either be connected
to a water drain or to a sink outlet spigot.
This connection should be at a minimum
of 50cm and a maximum of 110cm from
the floor. The drain hose should be no
longer than 4m in length to ensure good
performance from the
26
dishwasher.
Fig. 14
Fig. 15
Fig. 16
Advertisement
Table of Contents
