Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CDA WF140
Summary of Contents for CDA WF140
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model Serial Number This appliance has been designed for domestic use only.
-
Page 3: Before First Use
Control Panel Control Panel Power Button To switch the power to the dishwasher on or off, press the power button (1). When you switch on the dishwasher, the end of programme light will illumnate. Programme Selection Button To select a programme, press the programme selection button (2). The dishwasher will store in its memory the last programme used. -
Page 4: Control Panel
Press the Start/Pause button. • Turn the Programme Selection dial to 0, then press the Start/Pause button again. The dishwasher will drain for approximately thirty seconds, and the end progress indicator light will illuminate once the programme is cancelled. Switching the dishwasher off •... - Page 5 3. Then close the detergent compartment lid until the latch locks. detergent into the prewash section of the compartment (a in figure 1). CDA recommends the use of separate detergent, rinse aid and dishwasher salt rather than combination tablets as separates achieve better wash performance.
-
Page 6: Softener Adjustment
Keep the testing water testing The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher through strip in strip. is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the... -
Page 7: Rinse Aid
Rinse Aid Rinse Aid Rinse Aid To fill the rinse aid compartment To fill the rinse aid compartment To fill the rinse aid compartment 1. Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap as 1. -
Page 8: Dishwasher Baskets
Dishwasher Baskets Alternative basket loads To adjust the height of the upper basket: Lower Basket 1. Open the basket retaining clips, as shown in figure 7, but turning them to the side. 2. Remove the upper basket, and relocate the alternate set of wheels on the runner, as shown in figure 8, pushing the basket back into place. -
Page 9: Standard Loading And Test Data
Standard loading and Test Data Capacity • Upper and lower baskets: 12 place settings. • The upper basket should be adjusted to high position. • Cups should be placed on to the dish rack pins. Detergent / Rinse aid • 5 + 25 cm , in accordance with EN50242-DIN 44990 IEC 436 (international norms) / Rinse aid dosage adjustment: 4. -
Page 10: Programme Listing
The value and times provided in this table have been obtained under laboratory conditions according to relevant standards. This information can change depending on the condition of the dishwasher’s use and environment (network tension, water pressure, water input temperature and environment temperature.) -
Page 11: Care And Maintenance
Dishwasher interior To deal with an accumulation of dirt, oil or limescale in the dishwasher, run an intensive programme with detergent when the dishwasher is empty. Alternatively, there are specialist dishwasher cleaners available that can be used. -
Page 12: Failure Codes And Troubleshooting
Error code Your dishwasher control panel is equipped with a diagnostic display to help in the event of a problem with the appliance. Your dishwasher control panel is equipped with a diagnostic display to help in the event of a problem with... - Page 13 Failure Code and Troubleshooting Problem The programme will not start Water remains inside the dishwasher at the end of the programme The dishwasher stops in the middle of a programme Wash performance is of a low standard White stains on the dishes...
-
Page 14: Electrical Information
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. -
Page 15: Installation
This connection should be at a minimum of 50 cm and a maximum of 110 cm from the floor. The drain hose should be no longer than 4m in length to ensure good performance from the dishwasher. fig 14... - Page 16 Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
Need help?
Do you have a question about the WF140 and is the answer not in the manual?
Questions and answers