Input Channels Vs. Model; Conventions - Tektronix TDS 600B Performance Verification Manual

Performance Verification Procedures

Input Channels vs. Model

Conventions

1–2
When performing the procedures in this section, be aware that some TDS models
refer to input channels Ch 3 and Ch 4 as Aux 1 and Aux 2 respectively. Where
appropriate, both names will appear in the procedure, for example, Ch 3 (Aux 1).
The channel names for the various TDS models are shown below.
TDS Model
TDS 540C, 644B, 684B, 754C, and 784C
TDS 520C, 620B, 680B, and 724C
Throughout these procedures the following conventions apply:
Each test procedure uses the following general format:
Title of Test
Equipment Required
Prerequisites
Procedure
Each procedure consists of as many steps, substeps, and subparts as required
to do the test. Steps, substeps, and subparts are sequenced as follows:
1. First Step
a. First Substep
First Subpart
Second Subpart
b. Second Substep
2. Second Step
In steps and substeps, the lead-in statement in italics instructs you what to
do, while the instructions that follow tell you how to do it, as in the example
step below, "Initialize the oscilloscope" by doing "Press save/recall SETUP.
Now, press the main-menu button...".
TDS 500C, TDS 600B & TDS 700C Performance Verification and Specifications
Channel Names
Ch 1, Ch 2, Ch 3, and Ch 4
Ch 1, Ch 2, Aux 1, and Aux 2