Install Chimney Covers - Jenn-Air JXI8736DS Installation Instructions And Use & Care Manual

6. Run the home power supply cable through the strain relief,
into the terminal box.
A. Home power supply cable
B. UL listed or CSA approved strain relief
C. Location "L" (black wire)
D. Location "N" (white wire)
E. Location ground symbol (green or bare ground wire)
7. Loosen the screw labeled "L" on the terminal block and
connect black wire C. Retighten the screw.
8. Loosen the screw labeled "N" on the terminal block and
connect white wire D. Retighten the screw.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
9. Loosen the screw labeled with the "Ground Symbol" on the
terminal block and connect green (or bare) ground wire E.
Tighten the screw.
10. Tighten the strain relief screws.
11. Reinstall the terminal box cover.
12. Reconnect power.
A
B
C
D
E

Install Chimney Covers

1. On the upper chimney cover, bend out tabs (2) approximately
/ " (3 mm).
1
8
¹⁄₈"
(3 mm)
2. Slide rear flanges of upper chimney cover between catch
tabs on chimney cover mounting bracket and lock bent-
out tabs into slots in the back plate of the chimney cover
mounting bracket.
NOTE: Once the upper chimney cover tabs are locked into
the chimney cover mounting bracket, the upper chimney
cover will be hard to remove. If removal is required, place a
thin blade behind the top corner of the upper chimney cover
and the chimney cover mounting bracket to push in the
catch tabs on both sides and pull the rear side flange out
of the chimney cover mounting bracket.
3. Attach the 2 plastic spacers (F), one on each side at the
bottom of the blower module.
4. Widen the lower chimney cover and slide it over the upper
chimney cover and blower module. The lower chimney cover
must rest on the top of the hood.
A B
F
A. Ceiling
B. Chimney cover mounting bracket
C. Upper chimney cover - rear flanges
D. Upper chimney cover
E. Lower chimney cover
F. Plastic spacers (2)
C
D
E
13