Before First Use; Cleaning The Accessories Before Use; Operating The Appliance; Filling The Water Tank - Bosch HMT85DL53B Instruction Manual

Press the 0 button repeatedly until
3.
hardness range "medium").
Turn the rotary selector to change the water hardness range.
4.
Possible values:
softened
™† ‹
soft
™† ‚
medium
™† ƒ
hard
™† „
very hard
™† ...
Press and hold the button to exit basic settings.
0
5.
The change is saved.

Operating the appliance

In this section, you can read about
how to fill the water tank
■
how to switch the appliance on and off
■
what to note after each use
■
how to change the clock time
■

Filling the water tank

Press the symbol to open the appliance door. You can see
v
the water tank on the right.
Caution!
Use of unsuitable liquids may damage the appliance
Only use fresh tap water, softened water or uncarbonated
■
mineral water.
If your tap water is very hard, we recommend that you use
■
softened water.
Do not use distilled water, highly chlorinated tap water
■
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
™† ƒ appears (water
-
I
II
II
IV

Before first use

Before first use, heat the empty appliance for 20 minutes at
100 °C. Do not open the appliance door during this time. The
appliance is automatically calibrated (see section: Automatic
calibration).
Press the button to switch on the appliance.
#
1.
Fill the water tank and insert it (see section: Filling the
2.
water tank).
Press the n button.
3.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation automatically ends and a signal
sounds.
Press the button to switch off the appliance.
#
4.
Leave the appliance door ajar until the appliance has cooled
down.

Cleaning the accessories before use

Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
Fill the water tank before each use:
Open the appliance door and take out the water tank.
1.
Fill the water tank with cold water.
2.
MIN Amount of water required for approx. 30 minutes
steaming at 100 °C
MAX Amount of water required for approx. 2 hours
steaming at 100 °C

Slide in the water tank and push it in using the textured area
3.
on the bottom until it engages.
0 $ ;
7