Table of Contents
Advertisement
LMU-2x20™ Hardware and Installation Guide
Regulatory Information
Human Exposure Compliance Statement
Pursuant to 47 CFR § 24.52 of the FCC Rules and Regulations, personal communications
services (PCS) equipment is subject to the radio frequency radiation exposure requirements
specified in § 1.1307(b), § 2.1091 and § 2.1093, as appropriate. Calamp Wireless Networks
Inc. certifies that it has determined that the LMU-2630™ complies with the RF hazard
requirements applicable to broadband PCS equipment operating under the authority of 47
CFR Part 24, Subpart E of the FCC Rules and Regulations. This determination is dependent
upon installation, operation and use of the equipment in accordance with all instructions
provided. The LMU-2630™ is designed for and intended to be used in fixed and mobile
applications. "Fixed" means that the device is physically secured at one location and is not
able to be easily moved to another location. "Mobile" means that the device is designed to
be used in other than fixed locations and generally in such a way that a separation distance of
at least 20 cm is normally maintained between the transmitter's antenna and the body of the
user or nearby persons. The LMU-2630™ is not designed for or intended to be used in
mobile applications (within 20 cm of the body of the user) and such uses are strictly
prohibited. To ensure that the LMU-2630™ complies with current FCC regulations limiting
both maximum RF output power and human exposure to radio frequency radiation, a
separation distance of at least 20 cm must be maintained between the unit's antenna and the
body of the user and any nearby persons at all times and in all applications and uses.
Additionally, in mobile applications, maximum antenna gain must not exceed 3.2 dBi.
FCC Rules and Industry Canada (IC) regulatory information
Compliance Statement (Part 15.19)
The equipment device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by Calamp Wireless Networks could void
the user's authority to operate the equipment. Manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to this equipment.
Compliance Statement (Part 15.105(b))
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
V1.0.10
December 12, 2010
Copyright ©Calamp Wireless Networks Inc 2010
CalAmp Proprietary & Confidential
- v -
Advertisement
Table of Contents
