Toshiba RAV-RM1601BTP Series Service Manual page 61

Table of Contents

Advertisement

Step 4
Write the on-site setting data to the EEPROM, such as address setting, etc. Perform the steps 1 and 2
above again.
Step 5
Change the CODE No. (DN) to "
(this is the setting for the filter sign lighting time.)
Step 6
Check the setting data displayed at this time with the setting data put down in [1].
1. If the setting data is different, modify the setting data by pushing
the data put down in [1].
The operation completes if the setting data is displayed.
2. If the data is the same, proceed to next step.
Step 7
Change the CODE No. (DN) by pushing
As described above, check the setting data and modify to the data put down in [1].
Step 8
Repeat the steps 6 and 7.
Step 9
After the setting completes, push
(It takes approx. 1 min until the remote control operation is available again.)
∗ The CODE No. (DN) are ranged from "
Even after modifying the data wrongly and pushing
modification by pushing
<Fig. 3 EEPROM layout diagram>
The EEPROM (IC503) is attached to the IC socket. When detaching the EEPROM, use a tweezers, etc. Be
sure to attach the EEPROM by fitting its direction as shown in the figure.
∗ Do not bend the IC lead when replacing.
01 01 01 01 01
" by pushing
/
TEST
button to return to the normal stop status.
01 01 01 01 01
FF FF FF FF FF
" to "
". The CODE No. (DN) is not limited to be serial No.
button if the CODE No. (DN) is not changed.
CL
<Fig. 3>
- 61 -
FILE NO. SVM-18039
/
buttons for the temperature setting.
/
buttons for the timer setting to
buttons for the temperature setting.
SET
button, it is possible to return to the data before

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents