9.
Lay the exhaust hose to the wall outlet. Fix
the exhaust hose with the cable tie (1) on
the wall-outlet.
10.
Fix the top chimney on the installation bracket ( look also on step 8).
11.
Insert the grease filters and connect the appliance to the mains
Check the correct position of the hood from front and side perspective. Otherwise the
appliance will not work properly.
Carbon filter
1
open
3. Control panel
1
Off
2
Lowest setting
3
Medium setting
4
Highest setting
5
Light on/off
NOTICE! Only switch on the lights while the appliance is operating. Do not switch on
the lights to lighten the room.
If the socket is covered by the chimney, you must plug in the appliance at an
3
earlier point in
time.
Unplug the appliance before installing the
carbon filter.
For recirculating mode only.
2
close
20
3
.