Installation - Pkm 9004W Instruction Manual

1. The appliance must be transported and installed by at least two persons.
2. Unpack the parts of the chimney very carefully; otherwise you will damage the chimney
3. Remove the complete packaging materials before initial operation. The appliance may be
equipped with a transportation lock. Remove the transportation lock completely. When
removing be very careful. Do not use any aggressive detergents to remove residues of the
transportation lock.
4. Clean and maintain the appliance regularly to enable its proper operation and optimal
performance.
5. Take the enclosed parts from the packaging and its polystyrene-components.
6. Check that the power cord and the appliance are not damaged before electrical connection.

2. Installation

1. The diameter of the exhaust hose must meet the diameter of the connecting ring.
2. If your appliance is equipped with a carbon filter, remove the carbon filter before you operate
the appliance in the extraction mode. The carbon filter should be used in the
recirculating mode only.
3. The exhaust duct should be as short and straight as possible. The diameter of the exhaust
hose should be at least 120/150 mm (look at chapter T
have to expect increased noise and decreased performance of your appliance.
4. The proper maximum bending angle outwards is 120
5. Use smooth tubes or flexible, non-inflammable exhaust hoses only.
6. When the exhaust duct is connected horizontally, a minimum falling gradient of 1 cm/m or
an inclination of 2
7. When an exhaust duct is used, the ending of the exhaust hose must be adjusted into the
direction of flow.
8. If the exhaust duct passes through cool areas (e.g. an attic), a temperature gradient may occur
in the different parts of the exhaust duct so condensate will be generated. Proper insulation
of the corresponding parts of the exhaust duct will then be needed. Equip such an exhaust
duct with a condensate trap if need be.
9. Depending on the model the hood is equipped with one ( top ) or two ( top, back ) outlets.
10. The idle outlet is covered by a plastic cap. You can remove this cap by turning it
anticlockwise. Use the cap to cover the idle outlet.
Main components
0 is required. Otherwise condensate will get into the motor of the hood.
NOTICE!
ECHNICAL
0
.
17
D ). Otherwise you
ATA