Security; Boot - DFI KD631-C236 User Manual

Security

InsydeH2O Setup Utility
Main Advanced Security

Boot

Current TPM Device <TPM 2.0 (DTPM)>
TPM State All Hierarchies Enabled, UnOwned
TPM Availability <Available>
TPM Operation <No Operation>
Clear TPM [ ]
Supervisor Password Not installed
Set Supervisor Password
TPM Availability
Available
Hidden
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

TPM Availability
Set the TPM availability.
TPM Operation
Select one of the supported operation to change TPM2 state.
Clear TPM
Remove all TPM context associated with a specific owner.
Set Supervisor Password
Set the supervisor's password and the length of the password must be greater than
one character.
Chapter 3 BIOS Setup
Rev. 5.0
Exit
When Hidden, don't ex-
poses TPM to 0
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 3
Boot
Main Advanced
Numlock
Boot Type
Network Stack
PXE Boot capability
USB Boot
Quiet Boot
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

Numlock
Select the power-on state for numlock.
Boot Type
Select the boot type. The options are Dual Boot Type, Legacy Boot Type or UEFI Boot
Type.
If you select "Dual Boot Type" or "UEFI Boot Type", the "Network Stack", "PXE
Boot capability", "USB Boot" and "Quiet Boot" will show up.
If you select "Legacy Boot Type", "PXE Boot to LAN", "USB Boot" and "Quiet Boot" will
show up.
Note:
If the boot type is set to UEFI, the method for RAID volume creation will be different.
Please refer to Chapter 5 ˗ RAID for more information.
Network Stack
This field is used to enable or disable network stack.
PXE Boot capability
Disabled Suppoort Network Stack
UEFI PXE IPv4/IPv6
Legacy Legacy PXE OPROM only
45
InsydeH2O Setup Utility
Security Boot Exit
Selects Power-on state for
Numlock
<Off>
<Dual Boot Type>
<Disabled>
<Disabled>
<Enabled>
<Disabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Rev. 5.0
www.dfi .com