Installing The Fan And Heat Sink - DFI KD631-C236 User Manual

Installing the Fan and Heat Sink

The CPU must be kept cool by using a CPU fan with heat sink. Without sufficient air circula-
tion across the CPU and heat sink, the CPU will overheat damaging both the CPU and system
board.
Note:
A boxed Intel processor already includes the CPU fan and heat sink assembly. If your
®
CPU was purchased separately, make sure to only use Intel
sink.
1. Before you install the fan / heat sink, you must apply a thermal paste onto the top of the
CPU. The thermal paste is usually supplied when you purchase the fan / heat sink assem-
bly. Do not spread the paste all over the surface. When you later place the heat sink on
top of the CPU, the compound will disperse evenly.
Some heat sinks come with a patch of pre-applied thermal paste. Do not apply thermal
paste if the fan / heat sink already has a patch of thermal paste on its underside. Peel the
strip that covers the paste before you place the fan / heat sink on top of the CPU.
2. Place the heat sink on top
of the CPU. The 4 push-
pins around the heat sink,
which are used to secure
the heat sink onto the sys-
tem board, must match the
4 mounting holes around
the socket.
3. Orient the heat sink such
that the CPU fan's cable is
nearest the CPU fan con-
nector.
Chapter 2 Hardware Installation
Chapter 2
® -certified fan and heat
Mounting hole
19
9 9
CPU fan connector
19
9 9
14
4. Rotate each push-pin ac-
cording to the direction of
the arrow shown on top of
the pin.
Push down two pushpins
that are diagonally across
the heat sink. Perform the
same procedure for the
other two push-pins.
Heat sink
"Locked" position of
5. Connect the CPU fan's
cable to the CPU fan
connector on the system
board.
"Unlocked" position
of push-pin
push-pin
CPU fan connector
19
9 9
www.dfi .com